Cookies are small files held on your computer which allow us to give you the best browsing experience possible. You can delete and block cookies but parts of our site will not work without them. By using our website you accept our use of cookies.
Dilution rate* (all surfaces): Mix 50ml of Clensan per litre of water. (1 part Clensan to 20 parts water). Solutions should always be freshly prepared. *Norovirus: Mix 160ml of Clensan per litre of water and allow 60 minutes contact time for effective disinfection. Carpets & Upholstery: Always pre-test carpet or fabric with ready-to-use Clensan solution for colour fastness and texture change before proceedinFor professional and industrial use only. If used as part of the odour control programmes use with Crystal Green extraction shampoo at the correct dilution rates.
Apply Clensan solution by spray applicator to carpet or fabric surface and allow 5 to 15 minutes contact time for effective sanitising. Extraction rinse carpet or fabric with B109 Fibre & Fabric Rinse. Floors and Hard Surfaces: Always pre-test surface to be treated with ready-to-use Clensan solution before proceeding. Apply Clensan solution by spray applicator and allow 5 to 15 minutes contact time for effective sanitising. Wipe hard surfaces or rinse floors with water then mop or extract with wet pick-up vacuum. When using scrubber driers always check recovery tank for excessive foam and use defoamer if required. Clensan solutions should always be freshly prepared. Do not mix Clensan with other chemicals or detergents